Shop by Category Tools & Supplies Drills and Motors Parts & Maintenance


NZ $40.00 excl GST

MADC20 Dust collector canister filter relacement

Sorry, the selected product is currently out of stock. Sorry, there are only 1 of this item currently in stock. the selected product is not available.


Parts & Maintenance


Replacement canister filter for Foredom MADC-20 underbench dust collector

The dust collector motor has a safety electronic thermal overload prevention circuit which turns the motor off if it gets too hot. This can be caused by both filters being clogged, especially the canister filter MADC208 which is located under the HEPA filter bag.

To access the canister filter: remove the top connector tubing. Then loosen the thumb screws to the filter chamber compartment and twist it until the lid can be removed. You should replace the HEPA filter bag at this time. Then look down into the empty chamber and unscrew the knob screw on the canister filter lid and carefully remove the metal and rubber washers and lid. You can now lift out the canister filter and replace it. Reassemble and start working again.


In order to assist us in reducing spam, please type the characters you see:

You may also like